83320
1.INSPECT FUEL SENDER GAUGE ASSEMBLY
Check the fuel sender gauge assembly output voltage.
Apply 5 V between terminals 3 (FV) and 2 (FE).
Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.
Do not apply more than 6 V to terminals 3 (FV) and 2 (FE).
If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.
| *a | Component without harness connected
(Fuel Sender Gauge Assembly) |
| *b | Voltage applied between terminals |
Measure the voltage according to the value(s) in the table below.
| *a | Component without harness connected
(Fuel Sender Gauge Assembly) |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (FE) - 1 (FR) | Float position is F (upper) | 4.25 to 4.61 V* |
| Float position is E (lower) | 0.34 to 0.70 V* |
*: The output voltage changes depending on the voltage applied to the terminals.
Output voltage (F) = (0.850 x Voltage applied to terminals) to (0.922 x Voltage applied to terminals)
Output voltage (E) = (0.068 x Voltage applied to terminals) to (0.140 x Voltage applied to terminals)
If the result is not as specified, replace the fuel sender gauge assembly.