Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL FILTER
RM2660E _51 Engine / Hybrid System _052783 1VD-FTV FUEL _0255112 FUEL FILTER G

1VD-FTV FUEL  FUEL FILTER  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL FILTER ASSEMBLY

a.

Inspect the level warning switch.

i.
A181380E01
0.028,0.013 2.531,0.350 2.503,0.337 10 Component without harness connected: (Level Warning Switch) 1.547,1.266 1.663,1.411 0.116,0.145 10 2 1.801,1.266 1.917,1.411 0.116,0.145 10 1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Float upper end position Below 1 Ω
1 - 2 Float lower end position 1 MΩ or higher


If the result is not as specified, replace the fuel filter assembly.



b.

Inspect the clogging switch.

i.
A181381E01
0.038,0.026 2.541,0.364 2.503,0.338 10 Component without harness connected: (Clogging Switch) 1.501,1.495 1.612,1.640 0.111,0.145 10 2 1.856,1.495 1.967,1.640 0.111,0.145 10 1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) Below 1 Ω


If the result is not as specified, replace the fuel filter assembly.