89871A
1.INSTALL INJECTOR DRIVER
Be careful not to drop or strike the injector driver.
w/ DPF:
Install the No. 2 injector driver to the No. 2 injector driver bracket with the 4 screws.
w/o DPF:
Install the No. 2 injector driver and injector driver bracket to the No. 2 injector driver bracket with the 4 screws.
w/ DPF:
Install the No. 1 injector driver to the No. 1 injector driver bracket with the 4 screws.
w/o DPF:
Install the No. 1 injector driver and injector driver bracket to the No. 1 injector driver bracket with the 4 screws.
Install the No. 2 injector driver bracket to the No. 1 injector driver bracket with the 2 bolts.
w/ DPF:
Install the injector driver assembly with the 3 bolts.
Install the ground wire to the No. 2 injector driver bracket with the bolt.
| *A | for Type A |
| *B | for Type B |
Type A or B can be distinguished by confirming the mark on the bolt.
Connect the 7 injector driver connectors and attach the 2 wire harness clamps.
w/o DPF:
Install the injector driver assembly with the 3 bolts.
Attach the fuel hose clamp and wire harness clamp.
Connect the 4 injector driver connectors.
Install the ground wire to the No. 1 injector driver bracket with the bolt.
| *A | for Type A |
| *B | for Type B |
Type A or B can be distinguished by confirming the mark on the bolt.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Connect the cables to the negative (-) main battery and sub-battery terminals.