Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL PUMP
RM2660E _51 Engine / Hybrid System _052783 1VD-FTV FUEL _0255117 FUEL PUMP G

1VD-FTV FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

A158976E03
2.579,1.968 2.699,2.128 0.120,0.160 10 1 0.812,1.977 0.919,2.121 0.107,0.144 10 2 0.083,0.075 2.561,0.423 2.478,0.349 10 Component without harness connected: (Fuel Pump) 1.413,2.055 0.947,2.055 false 2.547,2.059 2.081,2.059 false

a.

Inspect the resistance of the fuel pump.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.
A181451E01
0.081,0.095 2.558,0.444 2.477,0.349 10 Component without harness connected: (Fuel Pump) 2.559,1.524 2.673,1.671 0.114,0.147 10 1 0.829,1.534 0.943,1.681 0.114,0.147 10 2 2.539,1.621 2.397,1.621 2.397,1.621 2.027,2.164 false 0.959,1.627 1.101,1.627 1.101,1.627 1.47,2.17 false

Inspect the operation of the fuel pump.

i.

Connect the battery's positive (+) lead to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

If the result is not as specified, replace the fuel pump and fuel pump ECU.

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.


·

Keep the fuel pump as far away from the battery as possible.


·

Always turn the voltage on and off on the battery side, not the fuel pump side.