Home › Engine / Hybrid System › 1GR-FE (EMISSION CONTROL) › AIR SWITCHING VALVE(for Bank 2)
RM2660E _51 Engine / Hybrid System _052784 1GR-FE EMISSION CONTROL _0255131 AIR SWITCHING VALVE(for Bank 2) G

1GR-FE EMISSION CONTROL  AIR SWITCHING VALVE(for Bank 2)  INSPECTION  


PROCEDURE

Hide 25702B 1.INSPECT NO. 2 EMISSION CONTROL VALVE SET

a.
A224405E02
0.215,0.363 0.389,0.526 0.173,0.163 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 5 20°C (68°F) 4.5 to 5.5 Ω
1 - Body ground Always 1 MΩ or higher
5 - Body ground


Text in Illustration
*a Component without harness connected
(No. 2 Emission Control Valve Set)

HINT:
·

When measuring the resistance, do not touch terminals 2, 3 or 4.

·

When measuring the resistance, make sure that the surface temperature of the No. 2 emission control valve set is 20°C (68°F).



If the result is not as specified, replace the No. 2 emission control valve set.


b.

Check the operation of the No. 2 emission control valve set.

i.
A224406E03
0.948,1.25 1.042,1.25 1.042,1.25 1.115,1.583 false 1.969,2.198 1.969,2.781 true 0.75,1.167 0.927,1.344 0.177,0.177 10 false *1 1.917,2.854 2.094,3.031 0.177,0.177 10 false *2

Check that air does not flow from port A to port B.

Text in Illustration
*1 Port A
*2 Port B
V100135

Air

NOTICE:

Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.


If the result is not as specified, replace the No. 2 emission control valve set.


ii.
A224407E02
1.445,4.389 1.622,4.555 0.177,0.166 10 *2 0.36,2.632 0.536,2.798 0.177,0.166 10 *1 0.557,2.717 0.695,2.717 0.695,2.717 0.906,3.224 false 1.555,4.376 1.555,4.232 1.555,4.232 1.636,3.843 false 0.216,0.071 0.392,0.237 0.177,0.166 10 *a

Apply battery voltage across terminals 1 and 5.

NOTICE:

When applying voltage, do not touch terminals 2, 3 or 4.



iii.

Check that air flows from port A to port B.

Text in Illustration
*1 Port A
*2 Port B
*a Component without harness connected
(No. 2 Emission Control Valve Set)
V100135

Air

If the result is not as specified, replace the No. 2 emission control valve set.