Home › Engine / Hybrid System › 1UR-FE (EMISSION CONTROL) › PURGE VALVE
RM2660E _51 Engine / Hybrid System _052785 1UR-FE EMISSION CONTROL _0255141 PURGE VALVE G

1UR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - Body ground Always 10 MΩ or higher
2 - Body ground


HINT:

When measuring the coil resistance, make sure that the surface temperature of the purge VSV is 20°C (68°F).


If the result is not as specified, replace the purge VSV.


b.

Check the operation of the purge VSV.

i.
A214835E02
1.167,0.938 1.292,0.938 1.292,0.938 1.583,1.313 false 0.958,1.417 1.104,1.417 1.104,1.417 1.281,1.677 false 0.792,1.333 0.99,1.5 0.198,0.167 10 false *2 1,1.896 1.198,2.063 0.198,0.167 10 false *a 0.99,0.854 1.188,1.021 0.198,0.167 10 false *1

Check that air does not flow from port E to port F.

Text in Illustration
*1 Port E
*2 Port F
*a Does not flow
V100135

Air pressure


ii.
A273505E01
0.13,1.277 0.303,1.443 0.173,0.166 10 *2 0.198,0.83 0.371,0.997 0.173,0.166 10 *1 0.396,0.918 0.499,0.918 0.499,0.918 0.797,1.256 false 0.33,1.367 0.436,1.367 0.436,1.367 0.511,1.634 false 1.395,1.704 1.499,1.880 0.104,0.176 10 1 1.509,1.955 1.617,2.119 0.108,0.164 10 2 1.511,1.79 1.74,1.79 1.74,1.79 1.955,1.704 false 1.63,2.04 1.762,2.04 1.762,2.04 2.145,1.704 false

Apply battery voltage to the connector and check the VSV operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Air flows from port E to port F


Text in Illustration
*1 Port E
*2 Port F
V100135

Air pressure

If the result is not as specified, replace the purge VSV.