Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › DPF SWITCH(for DPF) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052786 1VD-FTV EMISSION CONTROL _0255151 DPF SWITCH(for DPF) G

1VD-FTV EMISSION CONTROL  DPF SWITCH(for DPF)  INSPECTION  


PROCEDURE

Hide 84270K 1.INSPECT DPF SWITCH ASSEMBLY

a.
A271314

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 4 Switch OFF 10 kΩ or higher
1 - 4 Switch ON Below 1 Ω


If the result is not as specified, replace the DPF switch assembly.


b.

Apply battery voltage to the switch connector and check that the DPF switch illuminates.

OK:
Measurement Condition Specified Condition
Apply battery voltage to terminal 3 (+) and 2 (-) Mark illumination illuminates


If the result is not as specified, replace the DPF switch assembly.