Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › DPF SWITCH(for DPF) › from 2015.08
RM2660E _51 Engine / Hybrid System _052786 1VD-FTV EMISSION CONTROL _0255151 DPF SWITCH(for DPF) G

1VD-FTV EMISSION CONTROL  DPF SWITCH(for DPF)  INSPECTION  


PROCEDURE

Hide 84270K 1.INSPECT DPF SWITCH ASSEMBLY

a.
A375572E02
2.083,0.865 2.188,1.021 0.104,0.156 8 false 1 1.917,0.865 2.021,1.021 0.104,0.156 8 false 2 1.76,0.865 1.865,1.021 0.104,0.156 8 false 3 1.594,0.865 1.729,1.021 0.135,0.156 8 false 4 1.406,0.865 1.542,1.021 0.135,0.156 8 false 5 1.229,0.865 1.365,1.021 0.135,0.156 8 false 6 2.094,1.104 2.229,1.26 0.135,0.156 8 false 7 1.917,1.094 2.052,1.25 0.135,0.156 8 false 8 1.75,1.094 1.885,1.25 0.135,0.156 8 false 9 1.552,1.094 1.74,1.25 0.188,0.156 8 false 10 1.396,1.094 1.583,1.25 0.188,0.156 8 false 11 1.198,1.104 1.385,1.26 0.188,0.156 8 false 12 2.135,4.208 2.271,4.365 0.135,0.156 10 false 8 2.094,2.052 2.281,2.208 0.188,0.156 10 false 11 1.073,2.042 1.26,2.198 0.188,0.156 10 false 10 1.125,4.208 1.26,4.365 0.135,0.156 10 false 9

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
11 - 8 Switch OFF 10 kΩ or higher
11 - 8 Switch ON Below 1 Ω


If the result is not as specified, replace the DPF switch assembly.


b.

Apply battery voltage to the switch connector and check that the DPF switch illuminates.

OK:
Measurement Condition Specified Condition
Apply battery voltage to terminal 10 (+) and 9 (-) Mark illumination illuminates


If the result is not as specified, replace the DPF switch assembly.