Home › Engine / Hybrid System › 3UR-FE (EMISSION CONTROL) › PURGE VALVE
RM2660E _51 Engine / Hybrid System _052787 3UR-FE EMISSION CONTROL _0255156 PURGE VALVE G

3UR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

A148341E07
0.225,1.282 0.377,1.451 0.152,0.169 10 1 1.029,1.282 1.181,1.451 0.152,0.169 10 2 1.727,3.16 1.879,3.329 0.152,0.169 10 1 0.485,2.862 0.637,3.030 0.152,0.169 10 2 1.161,3.411 0.703,2.953 false 1.216,3.431 1.659,3.256 false 0.595,0.797 0.429,1.38 0.429,1.38 0.377,1.38 false 0.758,0.819 0.941,1.374 0.941,1.374 0.996,1.374 false 1.659,3.256 1.703,3.256 false 0.703,2.953 0.629,2.953 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - VSV body ground Always 10 kΩ or higher
2 - VSV body ground 10 kΩ or higher


If the result is not as specified, replace the purge VSV.


b.

Check the operation of the purge VSV.

i.
A148342E09
1.022,1.706 1.209,1.888 0.187,0.183 10 *a 1.364,0.699 1.520,0.878 0.157,0.179 10 E 1.076,1.429 1.233,1.609 0.157,0.179 10 F

Check that air does not flow from port F when air is applied to port E.

Text in Illustration
*a Does not flow
V100135

Air


ii.
A148343E12
1.813,1.646 1.552,1.646 1.552,1.646 1.479,1.188 true 1.531,1.198 2.063,1.198 true 0.979,0.844 1.146,1 0.167,0.156 10 false E 0.875,1.802 1.042,1.958 0.167,0.156 10 false F 2.104,1.104 2.219,1.271 0.115,0.167 10 false 2 1.844,1.552 1.958,1.719 0.115,0.167 10 false 1

Apply battery voltage to the connector, and check the VSV operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Air flows from port E to port F


Text in Illustration
V100135

Air

If the result is not as specified, replace the purge VSV.