Home › Engine / Hybrid System › 1UR-FE (INTAKE / EXHAUST) › VACUUM SWITCHING VALVE(for ACIS)
RM2660E _51 Engine / Hybrid System _052788 1UR-FE INTAKE / EXHAUST _0255163 VACUUM SWITCHING VALVE(for ACIS) G

1UR-FE INTAKE / EXHAUST  VACUUM SWITCHING VALVE(for ACIS)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17650 1.INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

a.

Disconnect the vacuum switching valve connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 37 to 44 Ω
1 - Body ground Always 1 MΩ or higher
2 - Body ground


If the result is not as specified, replace the vacuum switching valve assembly.


c.

Check the vacuum switching valve operation.

i.
A162111E05
2.198,1.177 2.198,1.563 false 2.125,1.583 2.302,1.74 0.177,0.156 10 false *1 0.969,0.448 1.156,0.594 0.188,0.146 10 false *a 1.406,0.802 1.573,0.969 0.167,0.167 10 false E 0.927,1.323 1.052,1.479 0.125,0.156 10 false F 2.75,0.74 2.906,0.896 0.156,0.156 10 false *b

When applying a vacuum to port E, check that air is sucked into the filter.

Text in Illustration
*1 Filter
*a Vacuum
*b Air


ii.
A162112E07
1.469,0.677 2.021,0.677 true 1.073,0.208 1.146,0.208 1.146,0.208 1.344,0.635 false 0.208,1.635 0.375,1.802 0.167,0.167 10 false *a 0.771,0.875 0.938,1.073 0.167,0.198 10 false E 0.615,1.198 0.74,1.365 0.125,0.167 10 false F 2.052,0.594 2.177,0.76 0.125,0.167 10 false 2 0.938,0.125 1.063,0.292 0.125,0.167 10 false 1 0.51,0.219 0.677,0.385 0.167,0.167 10 false *b

Apply battery voltage to the connector, and check the VSV operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Air is sucked into port E when a vacuum is applied to port F


Text in Illustration
*a Vacuum
*b Air

If the result is not as specified, replace the vacuum switching valve assembly.



d.

Connect the vacuum switching valve connector.