Home › Engine / Hybrid System › 1GR-FE (INTAKE / EXHAUST) › EXHAUST PIPE
RM2660E _51 Engine / Hybrid System _052791 1GR-FE INTAKE / EXHAUST _0255178 EXHAUST PIPE A

1GR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 89465 1.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 17430 2.REMOVE TAILPIPE ASSEMBLY

a.

Remove the bolt, clamp and gasket.


b.

Remove the tailpipe from the 2 exhaust pipe supports.


Hide 17420 3.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 4 bolts and 2 compression springs.


b.

Remove the center exhaust pipe from the 3 exhaust pipe supports.


c.

Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.


Hide 17450B 4.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the 2 nuts and front exhaust pipe.


c.

Remove the gasket from the front exhaust pipe.


Hide 89465A 5.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the 2 nuts and front exhaust pipe.


c.

Remove the gasket from the front exhaust pipe.