Home › Engine / Hybrid System › 3UR-FE (COOLING) › COOLING SYSTEM
RM2660E _51 Engine / Hybrid System _052793 3UR-FE COOLING _0255187 COOLING SYSTEM G

3UR-FE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

A178451

CAUTION:

Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Fill the radiator with coolant and attach a radiator cap tester.


b.

Warm up the engine.


c.

Using the radiator cap tester, increase the pressure inside the radiator to 123 kPa (1.3 kgf/cm2, 18 psi), and check that the pressure does not drop.

If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.


Hide 2.INSPECT ENGINE COOLANT LEVEL IN RESERVOIR

a.

Check that the engine coolant level is between the L and F lines when the engine is cold.

If the engine coolant is below the L line, check for leaks and add "TOYOTA Super Long Life Coolant" or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology to the F line.

NOTICE:

Do not substitute plain water for engine coolant.



Hide 3.INSPECT ENGINE COOLANT QUALITY

a.

Remove the radiator cap.

CAUTION:

Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



b.

Check if there are any excessive deposits of rust or scales around the radiator cap and radiator filler hole. Also, the coolant should be free of oil.

If excessively dirty, clean the coolant passage and replace the coolant.


c.

Install the radiator cap.


Hide 16210 4.INSPECT FLUID COUPLING ASSEMBLY

A164754

a.

Check the fluid coupling for damage or silicon oil leaks.

If necessary, replace the fluid coupling.