Home › Engine / Hybrid System › 1VD-FTV (LUBRICATION) › OIL LEVEL SENSOR
RM2660E _51 Engine / Hybrid System _052799 1VD-FTV LUBRICATION _0255223 OIL LEVEL SENSOR G

1VD-FTV LUBRICATION  OIL LEVEL SENSOR  INSPECTION  


PROCEDURE

Hide 89491 1.INSPECT ENGINE OIL LEVEL SENSOR

a.

Heat the switch to higher than 60°C (140°F) in an oil bath.


b.
A164340E03
2.323,0.833 3.042,0.49 3.042,0.49 3.198,0.49 true 2.438,1.01 3.073,1.167 3.073,1.167 3.208,1.167 true 3.25,0.406 3.385,0.583 0.135,0.177 10 false 1 3.26,1.073 3.396,1.25 0.135,0.177 10 false 2 2.938,2.448 3.229,2.615 0.292,0.167 10 false ON 2.906,2.917 3.25,3.083 0.344,0.167 10 false OFF

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 ON at 20°C (68°F) Below 1 Ω
OFF at 20°C (68°F) Below 1 Ω
ON at 60°C (140°F) Below 1 Ω
OFF at 60°C (140°F) 10 kΩ or higher


If the result is not as specified, replace the engine oil level sensor.