28300
1.INSPECT STARTER RELAY (ST)
for GRJ200L-GNANKC:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the starter relay.
except GRJ200L-GNANKC:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the starter relay.
28300D
2.INSPECT STARTER CUT RELAY (ST CUT)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the relay.
82733A
3.INSPECT MAIN BODY ECU (ACC RELAY)
Measure the resistance of the ACC relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2A-1 - 2D-8 | Battery voltage not applied between 2D-45 and 2D-62 | 10 kΩ or higher |
| Battery voltage applied between 2D-45 and 2D-62 | Below 1 Ω |
If the result is not as specified, replace the main body ECU.