Home › Engine / Hybrid System › 1GR-FE (STARTING) › IGNITION SWITCH
RM2660E _51 Engine / Hybrid System _052800 1GR-FE STARTING _0255231 IGNITION SWITCH G

1GR-FE STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT IGNITION SWITCH ASSEMBLY

a.
A172122E05
3.126,1.34 3.376,1.489 0.251,0.149 10 IG1 2.706,1.614 3.026,1.765 0.320,0.151 10 AM2 2.104,1.831 2.361,1.979 0.258,0.148 10 IG2 0.675,0.897 0.964,1.044 0.289,0.147 10 ST1 0.332,1.558 0.647,1.705 0.315,0.147 10 AM1 0.04,0.025 2.547,0.366 2.508,0.341 10 Component without harness connected: (Ignition Switch) 2.495,0.903 2.819,1.050 0.324,0.148 10 ACC 0.708,1.65 0.805,1.65 0.805,1.65 1.29,1.305 false 1.016,0.986 1.102,0.986 1.102,0.986 1.613,1.235 false 2.471,0.988 2.386,0.988 2.386,0.988 1.842,1.237 false 3.099,1.42 2.974,1.42 2.974,1.42 2.146,1.302 false 2.694,1.694 2.551,1.694 2.551,1.694 2.151,1.468 false 2.087,1.917 1.995,1.917 1.995,1.917 1.893,1.535 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
All combinations of all terminals LOCK 10 kΩ or higher
4 (AM1) - 2 (ACC) ACC Below 1 Ω
4 (AM1) - 2 (ACC)
4 (AM1) - 1 (IG1)
5 (AM2) - 6 (IG2)
ON
4 (AM1) - 1 (IG1)
4 (AM1) - 3 (ST1)
5 (AM2) - 6 (IG2)
START


If the result is not as specified, replace the ignition switch assembly.