89611
1.INSPECT ENGINE SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 7 (SS1) - 5 (GND) | Not pushed | 10 kΩ or higher |
| 2 (SS2) - 5 (GND) | Not pushed | 10 kΩ or higher |
| 7 (SS1) - 5 (GND) | Pushed | Below 1 Ω |
| 2 (SS2) - 5 (GND) | Pushed | Below 1 Ω |
| *a | Component without harness connected
(Engine Switch) |
If the result is not as specified, replace the engine switch.
Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
If the voltage is too low, the indicator will not illuminate.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND) |
Illuminates (illumination of lettering) |
| Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 5 (GND) |
Illuminates (green) |
| Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 5 (GND) |
Illuminates (amber) |
| *a | Component without harness connected
(Engine Switch) |
- | - |
If the result is not as specified, replace the engine switch.