Home › Engine / Hybrid System › 3UR-FE (STARTING) › ENGINE SWITCH › from 2015.08
RM2660E _51 Engine / Hybrid System _052801 3UR-FE STARTING _0255234 ENGINE SWITCH G

3UR-FE STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.
A295732E06
0.049,0.017 0.259,0.200 0.210,0.183 10 *a 0.293,0.418 0.605,0.588 0.312,0.170 10 SS1 2.791,0.418 3.103,0.588 0.312,0.170 10 SS2 2.795,1.584 3.249,1.754 0.455,0.170 10 AGND 0.566,1.76 0.941,1.930 0.375,0.170 10 SWIL 1.294,0.96 0.839,0.504 0.839,0.504 0.667,0.504 false 2.15,0.96 2.606,0.504 2.606,0.504 2.777,0.504 false 2.15,1.399 2.606,1.673 2.606,1.673 2.777,1.673 false 1.499,1.403 1.193,1.838 1.193,1.838 1.021,1.838 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND)
1 (SS2) - 6 (AGND)
Not pushed 10 kΩ or higher
5 (SS1) - 6 (AGND)
1 (SS2) - 6 (AGND)
Pushed Below 1 Ω


Text in Illustration
*a Component without harness connected
(Engine Switch)

If the result is not as specified, replace the engine switch.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


CAUTION:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

·

If the voltage is too low, the indicator will not illuminate.



If the result is not as specified, replace the engine switch.