28300
1.INSPECT STARTER RELAY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the starter relay.
28300D
2.INSPECT STARTER CUT RELAY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the starter relay.
82733A
3.INSPECT MAIN BODY ECU (ACC RELAY)
| *a | Component without harness connected
(Main Body ECU) |
- | - |
Measure the resistance of the ACC relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2A-1 - 2D-8 | Battery voltage not applied between 2D-45 and 2D-62 | 10 kΩ or higher |
| Battery voltage applied between 2D-45 and 2D-62 | Below 1 Ω |
If the result is not as specified, replace the main body ECU.