Home › Engine / Hybrid System › 1UR-FE (STARTING) › STARTER
RM2660E _51 Engine / Hybrid System _052802 1UR-FE STARTING _0255237 STARTER A

1UR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A258287

Remove the nut and disconnect the lead wire from terminal C.


b.
A258288

Remove the 2 nuts from the starter drive housing while holding the magnet starter switch.


c.
A452816

Pull the magnet starter switch and while lifting the front part of the magnet starter switch, release the plunger hook from the pinion drive lever and remove the magnet starter switch.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A258289

Using a T25 "TORX" socket wrench, remove the 2 bolts.


b.

Pull out the starter yoke together with the starter commutator end frame.


c.
A258293

Remove the 2 screws and starter commutator end frame from the starter yoke.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.



Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A215969

Using a screwdriver, pry the end of the spring away from each brush and pull out the 4 brushes from the starter brush holder so that they are held in place by the springs.


b.

Remove the starter brush holder.


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A262991

Remove the starter armature from the starter yoke.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A258315

Remove the starter armature plate from the starter center bearing clutch or starter yoke.


b.
A258316

Remove the 3 planetary gears from the starter center bearing clutch.


c.
A258317E02
2.33,0 2.499,0.152 0.169,0.152 10 *2 1.334,1.091 1.501,1.248 0.167,0.157 10 *1 2.494,1.538 2.667,1.687 0.173,0.149 10 *3 1.926,0.56 2.199,0.075 2.199,0.075 2.322,0.075 false 2.029,2.24 1.717,1.184 1.717,1.184 1.541,1.184 false 2.875,1.249 2.786,1.624 2.786,1.624 2.696,1.624 false

Remove the starter center bearing clutch together with the pinion drive lever and rubber seal from the starter drive housing.

Text in Illustration
*1 Starter Center Bearing Clutch
*2 Pinion Drive Lever
*3 Rubber Seal


d.

Remove the pinion drive lever and rubber seal from the starter center bearing clutch.