Home › Engine / Hybrid System › 1VD-FTV (STARTING) › GLOW PLUG › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052803 1VD-FTV STARTING _0255242 GLOW PLUG A

1VD-FTV STARTING  GLOW PLUG  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/DPF

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 17940D 3.REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

Hide 4.REMOVE INJECTION PIPES

Hide 19871 5.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.

Remove the 2 screw grommets and 2 nuts, and disconnect the 2 wire harnesses.


b.
A269587E03
0.083,0.125 0.271,0.292 0.188,0.167 10 false *a 0.083,2.219 0.271,2.385 0.188,0.167 10 false *b

Remove the 8 screw grommets, 8 nuts and 2 glow plug connectors.

Text in Illustration
*a RH
*b LH


Hide 19850 6.REMOVE GLOW PLUG ASSEMBLY

a.
A269588E03
0.083,0.125 0.271,0.292 0.188,0.167 10 false *a 0.104,2.24 0.292,2.406 0.188,0.167 10 false *b

Using a 10 mm deep socket wrench, remove the 8 glow plugs.

Text in Illustration
*a RH
*b LH

HINT:

Before removing the glow plugs, thoroughly clean off all dirt, sand, etc.