Home › Engine / Hybrid System › 1VD-FTV (STARTING) › STARTER › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052803 1VD-FTV STARTING _0255243 STARTER A

1VD-FTV STARTING  STARTER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/DPF

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines (See page Engine / Hybrid System>1VD-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM>ON-VEHICLE INSPECTION).



PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter with the 2 bolts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


b.
A270275E03
1.802,0.948 2.302,0.583 2.302,0.583 2.375,0.583 false 1.771,1.031 2.01,1.583 2.01,1.583 2.094,1.583 false 2.375,0.5 2.594,0.688 0.219,0.188 10 true *1 2.104,1.51 2.313,1.719 0.208,0.208 10 true *1

Connect the 2 starter hoses.

Text in Illustration
*1 Yellow Mark


c.

Attach the harness clamp and connect the wire harness.


d.

Connect the starter wire with the nut.

Torque:
20 N*m (200 kgf*cm, 14 ft.*lbf)


e.

Connect the starter connector.


Hide 25689 2.INSTALL EGR COOLER INSULATOR (w/ EGR System)

Hide 23920A 3.INSTALL FUEL COOLER ASSEMBLY (w/o DPF)

Hide 25620 4.INSTALL EGR VALVE ASSEMBLY (w/ DPF)

Hide 28800 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).