28300
1.INSPECT STARTER RELAY (ST)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the relay.
28610
2.INSPECT NO. 1 GLOW RELAY (GLOW NO. 1)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the relay.
19850
3.INSPECT NO. 2 GLOW RELAY (GLOW NO. 2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the starter relay.
82733A
4.INSPECT MAIN BODY ECU (ACC RELAY)
Before performing the relay inspections for the relay of the main body ECU, inspect the ECU-ACC fuse.
Measure the resistance of the ACC relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2G-1 - 2H-9 | Battery voltage not applied between 2J-18 and 2J-1 | 10 kΩ or higher |
| Battery voltage applied between 2J-18 and 2J-1 | Below 1 Ω |
| *a | Component without harness connected
Main Body ECU (Cowl Side Junction Block LH) |
- | - |
If the result is not as specified, replace the main body ECU.