Home › Engine / Hybrid System › 1VD-FTV (STARTING) › ENGINE SWITCH › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052803 1VD-FTV STARTING _0255245 ENGINE SWITCH G

1VD-FTV STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher
7 (SS1) - 5 (GND) Pushed Below 1 Ω
2 (SS2) - 5 (GND) Pushed Below 1 Ω


B106647E16
4.61,0.151 5.091,0.352 0.481,0.201 10 No Pin 2.847,0.125 3.196,0.326 0.349,0.201 10 GND 0.044,0.004 2.549,0.373 2.505,0.369 10 Component without harness connected: (Engine Switch) 3.378,0.734 3.248,0.221 false 3.248,0.221 3.172,0.221 false 5.023,0.759 5.504,0.960 0.481,0.201 10 No Pin 4.961,1.128 5.276,1.329 0.315,0.201 10 SS2 1.892,0.739 2.207,0.940 0.315,0.201 10 SS1 1.908,1.097 2.389,1.298 0.481,0.201 10 No Pin 3.055,0.922 2.423,1.198 false 2.423,1.198 2.363,1.198 false 3.93,0.737 4.497,0.247 false 4.497,0.247 4.58,0.247 false 3.833,0.151 4.314,0.352 0.481,0.201 10 No Pin 3.6,0.737 3.72,0.247 false 3.72,0.247 3.803,0.247 false 4.463,0.854 4.993,0.854 false 4.124,0.926 4.803,1.218 false 4.803,1.218 4.94,1.218 false 2.737,0.821 2.209,0.821 false

If the result is not as specified, replace the engine switch.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

HINT:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.


·

If the voltage is too low, the indicator will not illuminate.



OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND)
Illuminates (illumination of lettering)
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 5 (GND)
Illuminates (green)
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 5 (GND)
Illuminates (amber)


A178861E01
2.979,1.667 3.083,1.667 3.083,1.667 4.031,1.75 false 4.344,1.979 4.344,2.344 false 3.823,1.979 3.823,2.344 false 4.104,1.438 4.063,0.906 4.063,0.906 3.938,0.906 false 3.781,1.448 3.469,0.927 3.469,0.927 3.323,0.927 false 5.188,1.51 5.677,1.51 true 4.323,1.417 4.417,0.885 4.417,0.885 4.542,0.885 false 4.594,1.438 5.292,1 5.292,1 5.417,1 false 4.188,2.344 4.583,2.542 0.396,0.198 10 false SWIL 2.615,1.573 2.99,1.771 0.375,0.198 10 false INDS 3.646,2.354 4.063,2.552 0.417,0.198 10 false INDW 5.49,0.906 5.969,1.104 0.479,0.198 10 false No Pin 4.615,0.781 5.094,0.979 0.479,0.198 10 false No Pin 3.635,0.823 3.99,1.021 0.354,0.198 10 false GND 2.99,0.073 5.615,0.438 2.625,0.365 10 false Component without harness connected: (Engine Switch) 5.75,1.417 6.229,1.615 0.479,0.198 10 false No Pin 2.875,0.854 3.354,1.052 0.479,0.198 10 false No Pin

If the result is not as specified, replace the engine switch.