Home › Engine / Hybrid System › 1VD-FTV (STARTING) › ENGINE SWITCH › from 2015.08
RM2660E _51 Engine / Hybrid System _052803 1VD-FTV STARTING _0255245 ENGINE SWITCH G

1VD-FTV STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.
A295732E07
0.105,0.085 0.303,0.263 0.198,0.179 10 *a 0.236,0.578 0.546,0.737 0.310,0.160 10 SS1 2.865,0.578 3.175,0.737 0.310,0.160 10 SS2 2.865,1.622 3.316,1.781 0.451,0.160 10 AGND 1.222,1.056 0.754,0.665 0.754,0.665 0.608,0.665 false 2.21,1.056 2.678,0.665 2.678,0.665 2.825,0.665 false 2.21,1.326 2.678,1.717 2.678,1.717 2.825,1.717 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND) Not pushed 10 kΩ or higher
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND) Pushed Below 1 Ω


Text in Illustration
*a Component without harness connected
(Engine Switch)

If the result is not as specified, replace the engine switch.


b.
A295732E08
0.105,0.085 0.303,0.263 0.198,0.179 10 *a 0.409,1.746 0.805,1.906 0.396,0.160 10 SWIL 2.865,1.622 3.316,1.781 0.451,0.160 10 AGND 1.501,1.399 1.033,1.824 1.033,1.824 0.886,1.824 false 2.21,1.326 2.678,1.717 2.678,1.717 2.825,1.717 false

Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


Text in Illustration
*a Component without harness connected
(Engine Switch)

NOTICE:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

·

If the voltage is too low, the indicator will not illuminate.



If the result is not as specified, replace the engine switch.