The ECM receives signals from the skid control ECU (master cylinder solenoid) via CAN communication.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0122 | While the vehicle speed is 40 km/h (25 mph) or more and the cruise control main switch (ON/OFF) is on, signals cannot be received from the skid control ECU (master cylinder solenoid) for 2.6 seconds or more. | ·
Skid control ECU (master cylinder solenoid) ·
CAN communication system ·
ECM |
Refer to troubleshooting in CAN Communication System.
for LHD with Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD without Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD with Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD without Central Gateway ECU: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC U0122 is not output | A |
| DTC U0122 is output (for LHD with Central Gateway ECU) | B |
| DTC U0122 is output (for LHD without Central Gateway ECU) | C |
| DTC U0122 is output (for RHD with Central Gateway ECU) | D |
| DTC U0122 is output (for RHD without Central Gateway ECU) | E |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
E