Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255249 CRUISE CONTROL SYSTEM D

CRUISE CONTROL  CRUISE CONTROL SYSTEM  ROAD TEST  


PROBLEM SYMPTOM CONFIRMATION


a.
E349621

Inspect the SET function.

i.

Turn the main switch on.


ii.

Drive at the required speed (40 km/h (25 mph) or more).


iii.

Push the cruise control main switch to -SET.


iv.

Check that the "SET" indicator light illuminates in the combination meter assembly.


v.

After releasing the switch, check that the vehicle cruises at the set speed.



b.
E349622

Inspect the + (ACCELERATION) function.

i.

Turn the main switch on.


ii.

Drive at the required speed (40 km/h (25 mph) or more).


iii.

Push the cruise control main switch to -SET.


iv.

Check that the vehicle speed increases while the cruise control main switch is pushed to +RES, and that the vehicle cruises at the newly set speed when the switch is released.


v.

Momentarily push the cruise control main switch to +RES and then immediately release it. Check that the vehicle speed increases by approximately 1.6 km/h (1.0 mph) (tap-up control).



c.
E349621

Inspect the - (COAST) function.

i.

Turn the main switch on.


ii.

Drive at the required speed (40 km/h (25 mph) or more).


iii.

Push the cruise control main switch to -SET.


iv.

Check that the vehicle speed decreases while the cruise control main switch is pushed to -SET, and that the vehicle cruises at the newly set speed when the switch is released.


v.

Momentarily push the cruise control main switch to -SET, and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (tap-down control).



d.
E349624

Inspect the CANCEL function.

i.

Turn the main switch on.


ii.

Drive at the required speed (40 km/h (25 mph) or more).


iii.

Push the cruise control main switch to -SET.


iv.

When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.

·

Depressing the brake pedal.

·

Depressing the clutch pedal (for M/T).

·

Moving the shift lever from D to N (for A/T).

·

With the shift lever in S, selecting the S1, S2 or S3 range (for A/T).

·

Turning the main switch off.

·

Pulling the cruise control main switch to CANCEL.



v.

Set the cruise control, pull the cruise control main switch to CANCEL, and check that the "SET" indicator light illuminates in the combination meter assembly and normal driving is restored.



e.
E349622

Inspect the RES (RESUME) function.

i.

Turn the main switch on.


ii.

Drive at the required speed (40 km/h (25 mph) or more).


iii.

Push the cruise control main switch to -SET.


iv.

Cancel the cruise control system according to any of the above operations (other than turning the main switch off).


v.

After pushing the cruise control main switch to +RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle drives at the set speed.