If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
|---|---|---|
·
w/o Multi-information Display -
Cruise control indicator light illuminates in yellow ·
w/ Multi-information Display -
Cruise control indicator light turns off -
"CHECK CRUISE CONTROL SYSTEM" is displayed on the multi-information display in the combination meter |
·
There is an open or short in the stop light switch circuit ·
There is a problem with the vehicle speed signal |
Turn the cruise control main switch on again |
| Cruise control indicator light goes off | ·
There is a problem with the throttle position sensor and the motor*1 ·
There is a problem with the fuel injection system*2 |
Turn the cruise control main switch on again |
·
w/o Multi-information Display -
Cruise control indicator light illuminates in yellow ·
w/ Multi-information Display -
Cruise control indicator light turns off |
·
There is a problem with the input circuit of the stop light switch circuit ·
There is a problem with the cancel circuit |
Turn the ignition switch off |
| Cruise control indicator light remains on
(Cruise control is canceled) |
Under the following conditions, the stored vehicle speed is maintained:
·
The vehicle speed is less than the low speed limit (approx. 40 km/h (25 mph)) while running with the cruise control on ·
The VSC system is operated ·
A cancel request is received from the 4WD system |
Push the cruise control main switch to +RES |
·
The vehicle speed is less than the stored speed by approx. 16 km/h (10 mph) or more |
Push the cruise control main switch to -SET |
*1: for 1GR-FE, 1UR-FE, 3UR-FE
*2: for 1VD-FTV