If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
|---|---|---|
·
w/o Multi-information Display -
Cruise control indicator light illuminates in yellow ·
w/ Multi-information Display -
Cruise control indicator light turns off -
A warning message "Cruise Control Malfunction Visit Your Dealer" is displayed -
"Pong" warning sound is heard |
Open or short in stop light switch circuit | ·
Cruise control system is turned off ·
Push cruise control main switch on again |
·
Problem with stop light switch input circuit ·
Problem with cruise control main switch cancel circuit ·
Malfunction in the brake control system ·
Communication stop between skid control ECU (master cylinder solenoid) and ECM |
·
Turn ignition switch off ·
Push cruise control main switch on again |
|
| Cruise control indicator light goes off | ·
There is a problem with the throttle position sensor and the motor*1 ·
There is a problem with the fuel injection system*2 |
Turn the cruise control main switch on again |
| Cruise control indicator light remains on
(Cruise control is canceled) |
·
Vehicle speed is lower than low speed limit (approximately 40 km/h [25 mph]) while running with cruise control system on ·
Vehicle stability control system operates while driving with cruise control system controlling vehicle speed*3 ·
TRC operates for certain amount of time while driving with cruise control system controlling vehicle speed*3 ·
TRC and VSC are off*3 |
Push the cruise control main switch to +RES |
·
The vehicle speed is less than the stored speed by approx. 16 km/h (10 mph) or more |
Push the cruise control main switch to -SET |
*1: for 1GR-FE, 1UR-FE, 3UR-FE
*2: for 1VD-FTV
*3: w/ Vehicle Stability Control System