This DTC indicates a malfunction in the ECM.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0575 | ECM has a supervisory CPU and control ECU inside. When each input STP signal is different this DTC is output. This DTC is also output after 0.4 seconds have passed from the time a cruise cancel input signal (STP input) is input to the ECM. | ECM |
The ECM receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function remains on until the ignition switch is turned off.
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF).
Push the cruise control main switch to -/SET to begin control of vehicle speed by the cruise control system.
Check the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P0575 is output (for 1GR-FE) | B |
| DTC P0575 is output (for 1VD-FTV) | C |
| DTC P0575 is output (for 1UR-FE) | D |
| DTC P0575 is output (for 3UR-FE) | E |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
E