Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the driving support ECU assembly. The driving support ECU assembly determines information about the vehicle in front based on data from the radar sensor, and then decides how much acceleration and/or deceleration is needed to maintain the set distance. The driving support ECU assembly also requests the skid control ECU to apply brakes and sounds the pre-crash safety city buzzer.

WIRING DIAGRAM

E259149E88
1.073,0.5 2.135,0.771 1.063,0.271 10 false from IG Circuit 5.99,0.51 6.104,0.667 0.115,0.156 10 false B 5.698,1.26 5.948,1.427 0.25,0.167 10 false 28 5.979,1.406 6.313,1.552 0.333,0.146 10 false GND 5.677,0.385 5.979,0.719 0.302,0.333 10 false 7 5.917,2.177 7.135,2.552 1.219,0.375 10 false Driving Support ECU Assembly 5.604,1.99 5.958,2.24 0.354,0.25 10 false E164 3.594,0.688 4.646,0.906 1.052,0.219 10 false ECU-IG NO. 6

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK DRIVING SUPPORT ECU ASSEMBLY (B VOLTAGE)
a.
U166511E02
1.26,1.083 1.677,1.802 false 0.073,0 0.396,0.229 0.323,0.229 10 false *a 1.604,0.188 1.979,0.375 0.375,0.188 10 false E164 1.646,1.823 1.833,2.042 0.188,0.219 10 false B

Disconnect the E164 driving support ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E164-7 (B) - Body ground Engine switch on (IG) 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Driving Support ECU Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE POWER SOURCE CIRCUIT

2.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - BODY GROUND)
a.

Disconnect the E164 driving support ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E164-28 (GND) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR