Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U0100  Communication Stop from ECM to Distance Control ECU, VSC  U0122  Lost Communication with Vehicle Dynamics Control Module  U0123  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U1101  Lost Communication with Distance Control ECU  


DESCRIPTION

This DTC is output when a communication malfunction occurs between the sensors and ECUs.

DTC Code DTC Detection Condition Trouble Area
U0100 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and communication from the ECM to the distance control ECU stops.
·

Distance control ECU

·

CAN communication system

·

ECM


U0122 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and communication from the master cylinder solenoid (skid control ECU) to the ECM stops.
·

Master cylinder solenoid (skid control ECU)

·

CAN communication system

·

ECM


U0123 While cruise control is in operation (vehicle-to-vehicle distance control mode), the data sent from the yaw rate sensor to the distance control ECU is abnormal.
·

Distance control ECU

·

Yaw rate sensor

·

CAN communication system

·

ECM


U0126 While cruise control is in operation (vehicle-to-vehicle distance control mode), the data sent from the steering angle sensor to the distance control ECU is abnormal.
·

Distance control ECU

·

Steering angle sensor

·

CAN communication system

·

ECM


U1101 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and communication from the distance control ECU to the ECM stops.
·

Distance control ECU

·

CAN communication system

·

ECM



PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING for LHD, Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING for RHD).

Result
Result Proceed to
OK
(CAN DTC is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C



A

B

C