Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1572  Improper Aiming of Radar Sensor Beam Axis  


DESCRIPTION

This DTC is stored when there is a problem with the millimeter wave radar sensor beam axis adjustment.

DTC Code DTC Detection Condition Trouble Area
P1572 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the millimeter wave radar sensor beam axis is misaligned (0.15 seconds. or more). Millimeter wave radar sensor

HINT:

If the beam axis deviates vertically by +/-2° or more and/or horizontally by +/-4° or more at a distance of 4.0 to 6.0 m (13 to 20 ft), this DTC is stored.


CAUTION / NOTICE / HINT

NOTICE:

When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).


PROCEDURE

1.ADJUST MILLIMETER WAVE RADAR SENSOR
a.

Refer to the adjustment (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).

HINT:

It is necessary to make the ECM recognize specification information (whether the vehicle is equipped with the dynamic radar or not). If this procedure has not been carried out, this DTC may be output.




NEXT

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (30 mph) or more.


ii.

Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.



d.


OK

END

NG