Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Millimeter Wave Radar Sensor Power Source Circuit  


DESCRIPTION

When the engine switch is turned on (IG), battery voltage is applied to terminal IGB of the millimeter wave radar sensor assembly.

This circuit provides power to the millimeter wave radar sensor assembly. The millimeter wave radar sensor assembly emits radio waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front. This data is transmitted to the driving support ECU assembly.

WIRING DIAGRAM

E259147E29
4.052,2.156 4.292,2.333 0.24,0.177 10 false A72 4.979,1.51 5.448,1.667 0.469,0.156 10 false SGND 4.979,0.469 5.333,0.625 0.354,0.156 10 false IGB 4.75,1.354 4.865,1.51 0.115,0.156 10 false 1 4.75,0.333 4.865,0.49 0.115,0.156 10 false 8 4.052,2.354 6.615,2.615 2.563,0.26 10 false Millimeter Wave Radar Sensor Assembly 2.479,0.615 3.531,0.844 1.052,0.229 10 false ECU-IG NO. 2 0.417,0.448 1.396,0.823 0.979,0.375 10 false from IG circuit

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY (IGB VOLTAGE)
a.
U166516E02
1.927,1.24 2.25,1.74 false 0.083,0 0.281,0.177 0.198,0.177 10 false *a 0.438,1.021 0.708,1.177 0.271,0.156 10 false A72 2.115,1.75 2.385,1.948 0.271,0.198 10 false IGB

Disconnect the millimeter wave radar sensor assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A72-8 (IGB) - Body ground Engine switch on (IG) 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Millimeter Wave Radar Sensor Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE POWER SOURCE CIRCUIT

2.CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)
a.

Disconnect the A72 millimeter wave radar sensor assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
A72-1 (SGND) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR