Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC indicates a malfunction in the ECM.

DTC Code DTC Detection Condition Trouble Area
P0575 ECM has a supervisory CPU and control ECU inside. When each input STP signal is different this DTC is output. This DTC is also output after 0.4 seconds have passed from the time a cruise cancel input signal (STP input) is input to the ECM. ECM

HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function remains on until the ignition switch is turned off.


PROCEDURE

1.CHECK DTC OUTPUT (RADAR CRUISE1)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF).


iii.

Push the cruise control main switch to -/SET to begin control of vehicle speed by the cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise1 / Trouble Codes.


f.

Check the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC P0575 is not output A
DTC P0575 is output (for 1UR-FE) B
DTC P0575 is output (for 3UR-FE) C
DTC P0575 is output (for 1VD-FTV) D




A

B

C

D