Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255254 ROAD SIGN ASSIST SYSTEM C

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0101  Lost Communication with TCM  U0123  Lost Communication with Yaw Rate Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  U0155  Lost Communication with Combination Meter  


DESCRIPTION

These DTCs are output when a communication malfunction occurs between the sensors and ECUs.

DTC No. DTC Detection Condition Trouble Area
U0100 While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the ECM and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

ECM

·

Forward recognition camera


U0101 While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the TCM and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

TCM

·

Forward recognition camera


U0123 While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the yaw rate sensor and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Yaw rate and acceleration sensor (airbag sensor assembly)

·

Forward recognition camera


U0129 While the engine switch is on (IG), a communication error between the skid control ECU and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Skid control ECU (master cylinder solenoid)

·

Forward recognition camera


U0142 While the engine switch is on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Forward recognition camera


U0155 While the engine switch is on (IG), a communication error between the combination meter assembly and the forward recognition camera is detected for approximately 50 seconds or more.
·

CAN communication system

·

Combination meter assembly

·

Forward recognition camera



PROCEDURE

1.READ VALUE USING GTS (CAN BUS CHECK)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: System Select / CAN Bus Check.

Result:
Result Proceed to
All of the ECUs and sensors that are currently connected to the CAN communication system are displayed. A
None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed. B




A

2.DTC OUTPUT (ROAD SIGN ASSIST SYSTEM)

B

2.DTC OUTPUT (ROAD SIGN ASSIST SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Road Sign Assist / Trouble Codes.




NEXT

3.CHECK CAN COMMUNICATION SYSTEM
3.CHECK CAN COMMUNICATION SYSTEM
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Enter the following menus: System Select / CAN Bus Check.


d.

Select "Communication Malfunction DTC" from the "CAN Bus Check" screen, and then select "Enter".

OK:

CAN communication system is normal.




OK

NG