Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255255 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA9  Front Camera Module Beam Axis Not Adjusted  


DESCRIPTION

If the camera sensor beam axis adjustment is not performed after installing the forward recognition camera, DTC C1AA9 is stored.

DTC No. DTC Detection Condition Trouble Area
C1AA9 2 seconds after the engine switch is turned on (IG), the forward recognition camera detects that forward recognition camera adjustment has not been completed. Forward recognition camera

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera learning (See page Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT).



PROCEDURE

1.CHECK DTC OUTPUT (LANE DEPARTURE ALERT SYSTEM)
a.

Check if the stored DTCs are current DTCs.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / LKA/LDA / Trouble Codes.


f.

Make sure that the following conditions are met.

HINT:

If the conditions are not met, the system cannot detect the malfunction.

1.

Turn the engine switch on (IG) and wait 2 seconds or more.





Result
Result Proceed to
DTC C1AA9 is output A
DTC C1AA9 is not output B


A

2.PERFORM FORWARD RECOGNITION CAMERA OPTICAL AXIS LEARNING

B

2.PERFORM FORWARD RECOGNITION CAMERA OPTICAL AXIS LEARNING
a.

Adjust the forward recognition camera (See page Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT).



NEXT

3.CHECK DTC OUTPUT (LANE DEPARTURE ALERT SYSTEM)
3.CHECK DTC OUTPUT (LANE DEPARTURE ALERT SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / LKA/LDA / Trouble Codes.



f.

Make sure that the DTC detection conditions are met.

HINT:

If the conditions are not met, the system cannot detect the malfunction.

1.

Turn the engine switch on (IG) and wait 2 seconds or more.





Result:
Result Proceed to
DTC C1AA9 is not output. A
DTC C1AA9 is output. B



A

END (FORWARD RECOGNITION CAMERA WAS DEFECTIVE)

B

REPLACE FORWARD RECOGNITION CAMERA