These DTCs are output when a communication malfunction occurs between the sensors and ECUs.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the ECM and the forward recognition camera is detected for 5 seconds or more. | ·
CAN communication system ·
ECM ·
Forward recognition camera |
| U0101 | While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the ECM and the forward recognition camera is detected for 5 seconds or more. | ·
CAN communication system ·
ECM ·
Forward recognition camera |
| U0123 | While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the yaw rate sensor and the forward recognition camera is detected for 5 seconds or more. | ·
CAN communication system ·
Yaw rate and acceleration sensor (Airbag sensor assembly) ·
Forward recognition camera |
| U0129 | 2 seconds after the engine switch is turned on (IG), a communication error between the skid control ECU (master cylinder solenoid) and the forward recognition camera is detected for 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (Master cylinder solenoid) ·
Forward recognition camera |
| U0142 | 2 seconds after the engine switch is turned on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for 5 seconds or more. | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) ·
Forward recognition camera |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Clear DTCs (See page Engine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR).
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the engine switch on (IG) and wait 7 seconds or more.
Drive the vehicle at 1 km/h (1 mph) or more for 1 second or more.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC U0100, U0101, U0123, U0129 and U0142 are not output | A |
| DTC U0100, U0101, U0123, U0129 or U0142 is output (for LHD) | B |
| DTC U0100, U0101, U0123, U0129 or U0142 is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C