If the camera sensor beam axis adjustment is not performed after installing the forward recognition camera, DTC C1AA9 is stored.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AA9 | 2 seconds after the engine switch is turned on (IG), the forward recognition camera detects that forward recognition camera adjustment has not been completed. | Forward recognition camera |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera learning (See page Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT).
Check if the stored DTCs are current DTCs.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
Make sure that the following conditions are met.
If the conditions are not met, the system cannot detect the malfunction.
Turn the engine switch on (IG) and wait 2 seconds or more.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AA9 is output | A |
| DTC C1AA9 is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Adjust the forward recognition camera (See page Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT).
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR).
Make sure that the DTC detection conditions are met.
If the conditions are not met, the system cannot detect the malfunction.
Turn the engine switch on (IG) and wait 2 seconds or more.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AA9 is not output. | A |
| DTC C1AA9 is output. | B |
A
B