Refer to DTC P0894 (See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1VD-FTV)>P0894).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2716 | Conditions (a) or (b) below are detected for 1 sec. or more (1 trip detection logic).
(a) SLT - terminal: 0 V (b) SLT - terminal: 12 V |
·
Open or short in shift solenoid valve SLT circuit ·
Shift solenoid valve SLT ·
ECM |
When an open or short in the shift solenoid valve SLT circuit is detected, the ECM interprets this as a fault. The ECM will turn on the MIL and store the DTC.
Disconnect the No. 1 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 13 (SLT+) - 5 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 13 (SLT+) - Body ground | Always | 10 kΩ or higher |
| 5 (SLT-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C45-11 (SLT+) - C45-10 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| C45-11 (SLT+) - Body ground | Always | 10 kΩ or higher |
| C45-10 (SLT-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C46-11 (SLT+) - C46-10 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| C46-11 (SLT+) - Body ground | Always | 10 kΩ or higher |
| C46-10 (SLT-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the shift solenoid valve SLT.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
|---|---|
·
Battery positive (+) with a 21 W bulb → Terminal 2 ·
Battery negative (-) → Terminal 1 |
Valve moves and makes an operating noise |
OK
NG