The amount of current flow to the solenoid is controlled by the ECM. During the lock-up operation, if the current increases, the lock-up hydraulic pressure increases.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2759 | An open or short is detected in the shift solenoid valve SLU circuit for 1 sec. or more while driving (1 trip detection logic). | ·
Open or short in shift solenoid valve SLU circuit ·
Shift solenoid valve SLU ·
ECM |
When an open or short in the shift solenoid valve SLU circuit is detected, the ECM determines that there is a malfunction. The ECM will illuminate the MIL and store this DTC.
Disconnect the No. 1 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 12 (SLU+) - 4 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 12 (SLU+) - Body ground | Always | 10 kΩ or higher |
| 4 (SLU-) - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected
(No. 1 Transmission Wire) |
OK
NG
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C45-10 (SLU+) - C45-11 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| C45-10 (SLU+) - Body ground | Always | 10 kΩ or higher |
| C45-11 (SLU-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C46-10 (SLU+) - C46-11 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| C46-10 (SLU+) - Body ground | Always | 10 kΩ or higher |
| C46-11 (SLU-) - Body ground | Always | 10 kΩ or higher |
| *1 | for LHD |
| *2 | for RHD |
| *a | Front view of wire harness connector
(to ECM) |
OK
NG
OK
NG