Home › Drivetrain › AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE) › 2014.08–2015.08
RM2660E _52 Drivetrain _052805 AB60F AUTOMATIC TRANSMISSION / TRANSAXLE _0255273 AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE) D

AB60F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE)  MONITOR DRIVE PATTERN  


TEST MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.


HINT:

Performing this drive pattern is one method to simulate the malfunction detection conditions of the ECT.

The DTCs may not be stored through ordinary, everyday driving. Also, DTCs may not be stored through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).


ii.

Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.

Malfunctions are not detected when the atmospheric temperature is less than -10°C (14°F).



b.

Drive pattern

i.

Drive the vehicle through all the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 5th (lock-up ON) → 6th → 6th (lock-up ON).


ii.

Repeat the above drive pattern 3 times or more.

NOTICE:
·

When using the GTS, the monitor status can be checked in the Data List (See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE)>DATA LIST / ACTIVE TEST).

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.






C351414E02
2.313,1.802 2.938,0.375 2.938,0.375 3.115,0.375 false 4.927,2.146 5.229,1.156 5.229,1.156 5.365,1.156 false 1.75,2.51 2.552,4.021 2.552,4.021 2.708,4.021 false 3.219,3.104 3.427,3.448 3.427,3.448 3.583,3.448 false 0.344,0.573 2.333,0.771 1.99,0.198 10 false Vehicle Speed 0.094,1.083 1.083,1.323 0.99,0.24 10 false Approximately 0.083,1.302 2.688,1.5 2.604,0.198 10 false 100 km/h (62 mph) 0.094,1.813 1.083,2.052 0.99,0.24 10 false Approximately 0.094,2.042 2.698,2.24 2.604,0.198 10 false 80 km/h (50 mph) 1.021,2.969 1.177,3.167 0.156,0.198 10 false 0 0.281,3.344 3.646,3.542 3.365,0.198 10 false Warmed up sufficiently 3.167,0.292 6.333,1.094 3.167,0.802 10 false Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 minutes or more.* 5.417,1.073 7.073,1.292 1.656,0.219 10 false Lock-up ON Vehicle Speed 2.74,3.958 4.635,4.583 1.896,0.625 10 false Normal acceleration through all the gears from 1st to 6th 3.646,3.375 5.635,3.573 1.99,0.198 10 false Stop (Idling)

HINT:

*: Drive at such a speed in the uppermost gear so as to engage lock-up. The vehicle can be driven at a speed lower than the speed shown in the above diagram in lock-up.


NOTICE:

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (No. 1 ATF temperature sensor malfunction).