Home › Drivetrain › AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE) › from 2015.08
RM2660E _52 Drivetrain _052805 AB60F AUTOMATIC TRANSMISSION / TRANSAXLE _0255273 AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE) J

AB60F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE)  Pattern Select Switch Sport Mode Circuit  


DESCRIPTION

The ECM memory contains the programs for the normal and sport shift patterns and lock-up pattern.

By following the programs corresponding to the signals from the SPORT S/S+ (integration control and panel assembly), the park/neutral position switch and other various sensors, the ECM switches the solenoid valves on and off, and controls the transmission gear change and the lock-up clutch operation.

WIRING DIAGRAM

C344096E12
0.818,2.998 1.146,3.182 0.328,0.184 10 V9 0.818,3.167 3.545,3.350 2.727,0.184 10 Integration Control and Panel Assembly 2.352,2.453 2.532,2.637 0.180,0.184 10 E 2.578,2.715 2.897,2.898 0.319,0.184 10 5 2.578,1.279 2.897,1.463 0.319,0.184 10 3 5.091,1.809 5.410,1.992 0.319,0.184 10 4 5.004,2.298 5.323,2.482 0.319,0.184 10 22 2.578,2.298 2.897,2.482 0.319,0.184 10 2 2.578,1.809 2.897,1.992 0.319,0.184 10 8 5.013,1.266 5.333,1.450 0.319,0.184 10 39 2.353,2.04 2.728,2.224 0.375,0.184 10 B 2.363,1.021 2.543,1.205 0.180,0.184 10 P 2.185,1.55 2.541,1.734 0.356,0.184 10 2ND 5.286,2.166 5.762,2.350 0.477,0.184 10 SPCN 5.281,1.136 5.758,1.320 0.477,0.184 10 PWMS 5.29,1.68 5.767,1.864 0.477,0.184 10 SNWI 5.494,3.008 6.012,3.191 0.518,0.184 10 A38 5.486,3.205 5.935,3.389 0.449,0.184 10 ECM

CAUTION / NOTICE / HINT

When the SPORT S/S+ switch is pushed, switch contact is made and sport mode is selected. To cancel sport mode, push the NORM switch once.

PROCEDURE

1.INSPECT SPORT S/S+ SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
a.
C331266E20
0.735,1.835 1.030,2.037 0.295,0.202 10 E 0.818,1.835 1.282,1.183 false 0.097,0.02 0.393,0.222 0.295,0.202 10 *a 2.144,1.835 2.440,2.037 0.295,0.202 10 P 2.13,1.835 1.712,1.183 false

Remove the integration control and panel assembly (See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH(w/ Entry and Start System)>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (P) - 5 (E) SPORT S/S+ switch on Below 1 Ω
3 (P) - 5 (E) SPORT S/S+ switch off 10 kΩ or higher
2 (B) - 5 (E) NORM switch on Below 1 Ω
2 (B) - 5 (E) NORM switch off 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Integration Control and Panel Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - BODY GROUND)

NG

2.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - BODY GROUND)
a.
U165551E01
0.375,0.802 0.663,1.035 0.288,0.233 10 V9 2.407,1.683 2.703,1.885 0.295,0.202 10 E 2.4,1.664 2.011,1.06 false 0.097,0.02 0.393,0.222 0.295,0.202 10 *a

Disconnect the integration control and panel assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
V9-5 (E) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Integration Control and Panel Assembly)



OK

3.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - ECM)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - ECM)
a.
U164952E02
2.417,1.75 2.177,1.188 false 0.115,0.063 0.427,0.26 0.313,0.198 10 false *a 1.656,0.271 2.01,0.479 0.354,0.208 10 false A38 2.156,1.76 2.99,1.958 0.833,0.198 10 false 39 (PWMS)

Disconnect the ECM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
A38-39 (PWMS) - Body ground SPORT S/S+ switch on Below 1 Ω
A38-39 (PWMS) - Body ground SPORT S/S+ switch off 10 kΩ or higher
A38-22 (SPCN) - Body ground NORM switch on Below 1 Ω
A38-22 (SPCN) - Body ground NORM switch off 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to ECM)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR