The ECM memory contains the programs for the normal and sport shift patterns and lock-up pattern.
By following the programs corresponding to the signals from the SPORT S/S+ switch (integration control and panel assembly), the park/neutral position switch and other various sensors, the ECM switches the solenoid valves on and off, and controls the transmission gear change and the lock-up clutch operation.
When the SPORT S/S+ switch is pushed, switch contact is made and sport mode is selected. To cancel sport mode, push the NORM switch once.
Remove the integration control and panel assembly (See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH(w/ Entry and Start System)>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (P) - 5 (E) | SPORT S/S+ switch on | Below 1 Ω |
| 2 (B) - 5 (E) | NORM switch on | Below 1 Ω |
| 6 (P) - 5 (E) | SPORT S/S+ switch off | 10 kΩ or higher |
| 2 (B) - 5 (E) | NORM switch off | 10 kΩ or higher |
| *a | Component without harness connected
(Integration Control and Panel Assembly) |
OK
NG
Disconnect the integration control and panel assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V9-5 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Integration Control and Panel Assembly) |
OK
NG
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A38-39 (PWMS) - Body ground | SPORT S/S+ switch on | Below 1 Ω |
| A38-43 (SPCN) - Body ground | NORM switch on | Below 1 Ω |
| A38-39 (PWMS) - Body ground | SPORT S/S+ switch off | 10 kΩ or higher |
| A38-43 (SPCN) - Body ground | NORM switch off | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to ECM) |
OK
NG