89299F
1.INSPECT SUSPENSION CONTROL SWITCH (COMBINATION SWITCH)
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Suspension Control Switch (Combination Switch)) |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (P) - 16 (E) | Mode switch being pushed and held (PWR) | Below 1 Ω |
| Mode switch not pushed (PWR) | 10 kΩ or higher | |
| 4 (2ND) - 16 (E) | Mode switch being pushed and held (2ND) | Below 1 Ω |
| Mode switch not pushed (2ND) | 10 kΩ or higher |
If the result is not as specified, replace the suspension control switch (combination switch).