Home › Drivetrain › A750F (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › 2014.08–2017.08
RM2660E _52 Drivetrain _052806 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0255282 PARK / NEUTRAL POSITION SWITCH A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


a.

Install the switch to the manual valve shaft.


b.
C155872

Temporarily install the bolt.


c.
C155871E06
1.927,1.302 2.042,0.25 2.042,0.25 1.917,0.25 false 0.729,0.167 2.26,0.5 1.531,0.333 10 true New Lock Washer

Install a new lock washer and the nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.
C170829

Temporarily install the control shaft lever RH.


e.
C172409E03
1.01,0.198 1.156,0.365 0.146,0.167 10 false P 1.76,0.042 1.906,0.208 0.146,0.167 10 false N 1.51,0.344 1.656,0.51 0.146,0.167 10 false R

Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.


f.

Remove the control shaft lever RH.


g.
U152677E03
1.958,1.573 0.677,1.25 false 1.948,0.948 1.719,0.135 1.719,0.135 1.896,0.135 false 1.948,0.063 3.125,0.292 1.177,0.229 10 false Neutral Basic Line 0.208,1.146 0.74,1.344 0.531,0.198 10 false Groove

Align the groove with the neutral basic line.


h.

Hold the switch in position and tighten the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


i.
C155870

Using a screwdriver, bend the tabs of the lock washer.


j.

Install the transmission control rod bush and collar to the transmission control shaft lever RH.


k.
C170829

Install the transmission control shaft lever RH with the spring washer and nut.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


l.

Connect the switch connector.


Hide 33702B 2.CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

C170828

a.

Connect the shifting rod to the transmission control shaft lever RH with the pin.


b.

Install a new clip.