35301
1.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY
Using a dial indicator, measure the inside diameter of the oil pump body bush.
38.188 mm (1.50 in.)
If the inside diameter is more than the maximum, replace the oil pump body sub-assembly.
35370
2.INSPECT STATOR SHAFT ASSEMBLY
Using a dial indicator, measure the inside diameter of the stator shaft bush.
21.577 mm (0.849 in.)
32.08 mm (1.26 in.)
If the inside diameter is grater than the maximum, replace the stator shaft assembly.
35301
3.INSPECT CLEARANCE OF OIL PUMP ASSEMBLY
Push the driven gear to one side of the body.
Using a feeler gauge, measure the body clearance.
0.10 to 0.17 mm (0.00394 to 0.00669 in.)
0.17 mm (0.00669 in.)
If the body clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly.
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.
0.070 to 0.150 mm (0.00276 to 0.00591 in.)
0.150 mm (0.00591 in.)
If the tip clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly.
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.
0.02 to 0.05 mm (0.000787 to 0.00197 in.)
0.05 mm (0.00197 in.)
If the side clearance of both gears is more than the maximum, replace the drive gear, driven gear or pump body assembly.
There are 5 different thicknesses for the drive and driven gears.
| Mark | Thickness |
|---|---|
| 0 | 10.74 to 10.749 mm (0.42283 to 0.42319 in.) |
| 1 | 10.75 to 10.759 mm (0.42323 to 0.42358 in.) |
| 2 | 10.76 to 10.77 mm (0.42362 to 0.42401 in.) |
| 3 | 10.771 to 10.78 mm (0.42405 to 0.42441 in.) |
| 4 | 10.781 to 10.79 mm (0.42445 to 0.42480 in.) |
35321
4.INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION
Place the oil pump body on the torque converter clutch.
Check that the drive gear rotates smoothly.
Remove the oil pump assembly from the torque converter.