Home › Drivetrain › A750F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM(for 1GR-FE) › 2014.08–2017.08
RM2660E _52 Drivetrain _052806 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0255290 AUTOMATIC TRANSMISSION SYSTEM(for 1GR-FE) D

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 1GR-FE)  HYDRAULIC TEST  


PERFORM HYDRAULIC TEST


a.

Measure the line pressure.

CAUTION:

The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stoppers outside the vehicle while the other is performing the test.


NOTICE:
·

Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80°C (122 to 176°F).

·

Be careful to prevent SST hose from interfering with the exhaust pipe.

·

This check must be conducted after checking and adjusting the engine.

·

Perform the check with the A/C turned off.

·

When conducting the stall test, do not continue for more than 5 seconds.



i.

Warm up the ATF (Automatic Transmission Fluid).


ii.

Turn the engine switch off.


iii.

Lift the vehicle up.


iv.
C159068E02
2.417,0.594 2.26,0.771 false 1.552,3.677 1.104,4.073 1.104,4.073 1.042,4.073 false 0.375,1.479 0.292,1.781 false 2.115,0.802 2.458,0.99 0.344,0.188 10 false SST 0.427,3.979 1.094,4.167 0.667,0.188 10 false Test Plug 0.135,1.823 0.479,2.01 0.344,0.188 10 false SST

Remove the test plug on the transmission case center right side and connect SST.

SST
09992-00095  (09992-00231, 09992-00271)


v.

Lower the vehicle.


vi.

Fully apply the parking brake and chock the 4 wheels.


vii.

Start the engine and check the idling speed.


viii.

Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.


ix.

Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches stall speed.


x.

In the same manner, perform the test with the shift lever in R.

Specified Line Pressure
Condition D Position R Position
Stall test 1360 to 1480 kPa
(13.9 to 15.1 kgf/cm2, 197 to 215 psi)
1290 to 1520 kPa
(13.2 to 15.5 kgf/cm2, 187 to 220 psi)

Evaluation
Problem Possible Cause
Measured values at D and R positions are higher than specified pressure
·

Shift solenoid valve SLT defective

·

Regulator valve defective


Measured values at D and R positions are lower than specified pressure
·

Shift solenoid valve SLT defective

·

Regulator valve defective

·

Oil pump defective


Pressure is low in D position only
·

D position circuit fluid leak

·

Clutch No. 1 (C1) defective


Pressure is low in R position only
·

R position circuit fluid leak

·

Clutch No. 3 (C3) defective

·

Brake No. 4 (B4) defective