84540
1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Park/Neutral Position Switch Assembly) |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (IG) - 4 (C) | Shift lever in D and S | Below 1 Ω |
| 6 (IG) - 5 (A) | Shift lever in P and R | Below 1 Ω |
| 6 (IG) - 7 (PA) | Shift lever in P and N | Below 1 Ω |
| 6 (IG) - 9 (B) | Shift lever in R, N, D and S | Below 1 Ω |
| 1 (RB) - 2 (RL) | Shift lever in R | Below 1 Ω |
| 3 (B) - 4 (C) | Shift lever in P and N | Below 1 Ω |
| 6 (IG) - 4 (C) | Shift lever not in D and S | 10 kΩ or higher |
| 6 (IG) - 5 (A) | Shift lever not in P and R | 10 kΩ or higher |
| 6 (IG) - 7 (PA) | Shift lever not in P and N | 10 kΩ or higher |
| 6 (IG) - 9 (B) | Shift lever not in R, N, D and S | 10 kΩ or higher |
| 1 (RB) - 2 (RL) | Shift lever not in R | 10 kΩ or higher |
| 3 (B) - 4 (C) | Shift lever not in P and N | 10 kΩ or higher |
If the result is not as specified, replace the park/neutral position switch assembly.