Home › Drivetrain › AE80F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › from 2015.08
RM2660E _52 Drivetrain _052807 AE80F AUTOMATIC TRANSMISSION / TRANSAXLE _0255308 AUTOMATIC TRANSMISSION SYSTEM D

AE80F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  MONITOR DRIVE PATTERN  


MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.


HINT:

Performing this drive pattern is one method to simulate TCM (ECT) malfunction detection conditions.

Some DTCs may not be detected through ordinary, everyday driving. DTCs may not be detected through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature of 60°C (140°F) or higher).


ii.

Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.

Some malfunctions are not detected when the atmospheric temperature is below -10°C (14°F).



b.

Drive pattern

i.

Drive the vehicle through all the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 7th → 8th → 8th (lock-up ON).


ii.

Perform an engine braking test with the shift lever in S. While driving in the S8 range and 8th gear lock-up, move the shift lever to "-" and down-shift from 8th → 7th, 7th → 6th, 6th → 5th, 5th → 4th, 4th → 3rd, 3rd → 2nd and 2nd → 1st.

Check that engine braking is normal for every down-shift.


iii.

Repeat the above drive pattern 3 times or more.

NOTICE:
·

When using the GTS, the monitor status can be checked in the Data List (See page Drivetrain>AE80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DATA LIST / ACTIVE TEST).

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

·

Perform this drive pattern on a level road as much as possible and strictly observe the posted speed limits and traffic laws while driving.

·

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (Transmission Fluid Temperature Sensor "A" Performance).






C115866E40
0.198,0.438 1.146,0.646 0.948,0.208 10 Vehicle Speed 2.874,0.159 6.264,0.627 3.389,0.469 10 Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 minutes or more.* 5.299,1.131 7.038,1.351 1.739,0.219 10 Lock-up ON Vehicle Speed 3.371,3.406 4.210,3.616 0.839,0.210 10 Stop (Idling) 2.547,3.892 4.638,4.254 2.091,0.362 10 Normal acceleration through all the gears from 1st to 8th 0.133,3.297 1.660,3.580 1.527,0.283 10 Warmed up sufficiently 0.964,2.909 1.131,3.125 0.167,0.216 10 0 0.158,1.935 1.106,2.461 0.948,0.526 10 Approximately 80 km/h (50 mph) 0.186,0.843 1.160,1.401 0.975,0.558 10 Approximately 100 km/h (62 mph) 2.546,3.89 1.617,2.487 false 3.371,3.406 3.108,3.008 false 2.223,1.693 2.756,0.254 2.756,0.254 2.823,0.254 false 4.881,2.045 5.186,1.225 5.186,1.225 5.253,1.225 false

HINT:

*: Drive at a speed in highest gear that will cause lock-up to engage. The vehicle can be driven at a speed lower than the speed shown in the above diagram under lock-up.