Home › Drivetrain › AE80F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › from 2015.08
RM2660E _52 Drivetrain _052807 AE80F AUTOMATIC TRANSMISSION / TRANSAXLE _0255308 AUTOMATIC TRANSMISSION SYSTEM C

AE80F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  P062F  Internal Control Module EEPROM Error  


DESCRIPTION

The TCM monitors its internal operation and it will set this DTC when it detects an internal malfunction.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P062F
1.

The engine switch is on (IG)

2.

TCM internal error (EEPROM)

3.

-

4.

1-trip detection logic


TCM

MONITOR DESCRIPTION

The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM will illuminate the MIL and store this DTC.

CAUTION / NOTICE / HINT

NOTICE:
·

Perform registration and/or initialization when parts related to the automatic transmission are replaced (See page Drivetrain>AE80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).

·

There is a possibility that DTC P062F is issued from the ECUs of the ECM and TCM. Use the GTS to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.



HINT:

After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the engine switch on (IG) and wait for 10 minutes or more.



PROCEDURE

1.READ OUTPUT DTC (DTC P062F)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Clear the DTCs (See page Drivetrain>AE80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).

HINT:

Write down the currently output DTCs before clearing them.



e.

Turn the engine switch off and turn the GTS off.


f.

Disconnect the GTS.


g.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


h.

Connect the cable to the negative (-) battery terminal.


i.

Connect the GTS to the DLC3.


j.

Turn the engine switch on (IG).


k.

Turn the GTS on.


l.

Enter the following menus: Powertrain / ECT / Trouble Codes.


m.

Read the DTCs using the GTS.

Result
Result Proceed to
DTCs are not output A
DTC P062F is output B



A

B